Anritrsu MP1763C 脉冲图形产生器 Anritrsu MP1763C

The amplitude of the clock and data signals can be varied from 0.25 to 2 Vp-p while the offset can be adjusted to within ±2 V so that the amplitude and the offset margin can be measured. The clock has a variable delay function so that time dependent characteristics or phase margins of the input clock and data can be measured. An M-series pseudorandom pattern representative of actual conditions or a programmable pattern can be selected as cell data.

1/8 parallel output is standard, and options are available for either 1/4 parallel output or 1/4 differential output. This is the industry's only 12.5G BERT system with differential inputs and ¼ differential outputs required for SAN market device applications.

In addition, a 3.5 inch floppy disk drive is built in for storing preset data, enabling rapid measurements to be performed by simply pressing a key. A GPIB function is provided, enabling automatic or remote measurement via an external controller.

The MP1763C pulse pattern generator is ideal for research and development of high-speed logic, ICs, and digital systems.

• High quality waveform
• Wide frequency range covers STM 0/STS1 to 10 GbE, STM64/STS192, OUT-2, and 4.25G Fibre Channel
• Low FM/PM-noise clock generator
• Differential inputs
• 1/8 parallel output standard, with available options for either 1/4 parallel output or 1/4 differential output
• 8 Mbit programmable pattern corresponding to six frames of STM-64/ STS-192
• Complementary outputs for both data and clock
• Settable amplitudes and offsets for all 8 data outputs with 1/8 speed of the fundamental clock signal