产品简介
特点介绍 New Gas Generator to
公司简介
东方化玻(北京)科技有限公司成立于 2014 年,是实验设备、平台综合解决方案提供商。公司为国内企事业单位 提供高品质仪器仪表,实验设备以及整体解决方案。 公司与国内外多家世界生产商已建立长期合作关系。公司经营产品广泛,灵活满足不同事业单位和企业客户的差异化需求 以及快速创新的追求,产品故障率低,维护成本小,性能优异,售后服务完善。公司产品在行业内均拥有持续的应用历史并 经过市场实际应用检验。 坚持以持续技术创新为客户不断创造价值为经营理念,公司在产品研发方面投入比例逐年递增,目前自主研发并投入市场 的产品已达十余种,长期以来,公司一直按照标准,搭建实验室平台,构建高品质、高标准、持续创新的发展体系。 坚持稳步发展的管理理念,不断刷新自己在业内的记录。
展开
产品说明
特点介绍
New Gas Generator to check personal Gas Detectors
A Test in just 10 Seconds
Personnel working in chemical plants protect themselves with personal gas detectors from gas exposure. Gas leaks are very unlikely to occur, so the gas detector will always display „0“.
An instrument displaying zero can do so for two reasons:
a) The concentration is zero.
b) The instrument is defective.
For good reasons a daily check of the instrument is mandatory. It would be too time consuming to perform a complete calibration every day. l regulations allow calibration intervals of up to six months.
The daily functional test with the gas generator makes sure that no instrument failure caused by abuse or wear and tear will go unnoticed. To perform a test it is sufficient to expose the sensor to a short puff of gas and see if the instrument gives an alarm. To make this test as fast, easy and cheap as possible, no accurate gas concentration is used, but approximately twice the value of the alarm threshold.
The quality criterion for the detector is not reaching a certain value, but the response time: A good sensor is also a fast sensor. So the gas generator stops gas generation after 10 seconds automatically. If the detector fails to alarm within this time interval it is not safe to be used. Thus the generator test reliably indicates the following potential errors:
- Defective electronics
- Alarm buzzer or lamp defective
- Sensor defective
- Sensor too slow
- Sensor not sensitive enough
Compur Monitors introduces a new gas generator model with the following features:
The flow of the built- in pump is adjusted to perfectly simulate the operating conditions of the gas detector.
The gas generator itself consists of an electrochemical cell filled with a electrolyte paste. This cell will only generate gas when it is activated by putting a gas detector on the receptacle.
The amount of gas produced when activated is very small. Therefore no restrictions regarding transportation and storage of the gas generator apply.
The gas generator is very easy to use. The gas detector operates a switch when put onto the receptacle. Ga
技术指标
New Gas Generator to check personal Gas Detectors
A Test in just 10 Seconds
Personnel working in chemical plants protect themselves with personal gas detectors from gas exposure. Gas leaks are very unlikely to occur, so the gas detector will always display „0“.
An instrument displaying zero can do so for two reasons:
a) The concentration is zero.
b) The instrument is defective.
For good reasons a daily check of the instrument is mandatory. It would be too time consuming to perform a complete calibration every day. l regulations allow calibration intervals of up to six months.
The daily functional test with the gas generator makes sure that no instrument failure caused by abuse or wear and tear will go unnoticed. To perform a test it is sufficient to expose the sensor to a short puff of gas and see if the instrument gives an alarm. To make this test as fast, easy and cheap as possible, no accurate gas concentration is used, but approximately twice the value of the alarm threshold.
The quality criterion for the detector is not reaching a certain value, but the response time: A good sensor is also a fast sensor. So the gas generator stops gas generation after 10 seconds automatically. If the detector fails to alarm within this time interval it is not safe to be used. Thus the generator test reliably indicates the following potential errors:
- Defective electronics
- Alarm buzzer or lamp defective
- Sensor defective
- Sensor too slow
- Sensor not sensitive enough
Compur Monitors introduces a new gas generator model with the following features:
The flow of the built- in pump is adjusted to perfectly simulate the operating conditions of the gas detector.
The gas generator itself consists of an electrochemical cell filled with a electrolyte paste. This cell will only generate gas when it is activated by putting a gas detector on the receptacle.
The amount of gas produced when activated is very small. Therefore no restrictions regarding transportation and storage of the gas generator apply.
The gas generator is very easy to use. The gas detector operates a switch when put onto the receptacle. Ga
本页产品地址:http://www.geilan.com/sell/show-28378.html